Does anyone know of a good way to attach door pulls to a TR6?

Rimmer Bros say that I screw in the pull to the door and because they are only small screws that I will need to then glue it. My concern is that I'll then be unable to remove the door panel if I'll need to.

Any ideas would be appreciated.

Many thanks,
Tom.

I am sure that the locations for the captive nuts as fitted to the TR4 are sited on the doors so that you could use door pulls as fitted to the TR4. You would need to take the door card to check it out. Alternatively you could fit a support to the door card such as large washers to spread the load and bolt through onto the door card the door card would have to be well secured of course. My mates 6 has door pulls fitted so I am sure it can be done.