I've just fitted a Kent road cam (Moss TT1104N) in my 4A.
The standard cams appear to be made of cheese so I went for a better made one ( that didn;t work out either)
Anyway, it is installed and set up using the Moss instructions -
Set crank to TDC
Turn crank to install angle - 108' (90 + 1
Set #1 inlet cam lobe to TDC
Couple crank to cam.
This all went OK (I think)
This morning I started it for the first time. Can't achieve a tick over below 1500rpm. So carried out the cam bedding procedure
200 - 3000 rpm for 20 minutes.
At 2000rpm the #1 spark occurs at apprx 10'btdc. At 800rpm it should be 10'btdc so is the 2000 too low.
Any tips/help appreciated as to why the low tick over can't be obtained.